本機特點

1、采用先進的美國PANGBORN設計技術，從而使機器外貌構思新穎，操作使用及維修十分方便。

1、 Adopt the Advanced Pangborn Design Technology, so that the appearance of the machine is novel, operation and maintenance is very convenient.

2、打砂室共6臺打砂器的布置，坐標位置采用（Computer Aided Design）三維動態拋射仿真后確定確保單側一只拋丸器仍然可以覆蓋整個工件的一側。

2、The layout of six sand blowers in the sanding chamber was determined by Computer Aided Design (Computer Aided Design) after three-dimensional dynamic projection simulation to ensure that one shot blast can still cover the whole side of the workpiece.

3、配有大流量除塵排風系統，使清理室體始終保持一定的負壓，從而循環室體內的氣流冷卻室內空氣以及彈丸的溫度，使打砂達到最高效率強度。

3、Equipped with a large flow dust removal and exhaust system, so that the clean room always keep a certain negative pressure, so that the air in the circulation room cooling room air and the temperature of the projectile, so that the sand to achieve the highest efficiency intensity

4、采用先進的沙塵分離器，粉塵分離效果好，噴砂效率高。

4、Adopt advanced sand-dust separator, dust separation effect is good, sandblasting efficiency is high.

5、氣動控制閥裝置，有效控制砂丸器開、停時間，避免砂丸器無效空拋，節約能量，提高室體護板，打砂器等易件壽命。

5, pneumatic control valve device, effective control shot open, stop time, to avoid shot invalid air-cast, save energy, improve the chamber plate, sand grinder and other components life.

6、使用砂料為：缸砂、鋼丸、不銹鋼丸、圓角鋼砂等。

6、Use Sand: cylinder sand, steel shot, stainless steel shot, round angle steel sand, etc.

使用范圍：本系列合適于平板類和各類中小型結構件的打砂清理，以去掉工件表面上的鐵銹，氧化皮，污物等使工件表面呈現金屬本色，消除工作內部應力，增加工件噴漆時的漆膜對著力。

本機參數